Overview
Determine the placement of the brackets on the wall. Install all brackets except for the final pulley bracket. Clip track into the brackets & install final bracket. Install cord guide for all looped corded tracks.
Most people like to have about a 1 - 1.5cm clearance of the curtains from the floor.
This is achieved by:
Adding 4cm to the hook drop of the curtain for a 1cm clearance
Adding 4.5cm to the hook drop of the curtain for
a 1.5cm clearance.
Use this measurement to position the track brackets.
End Pulley Bracket: mounted vertically
Measure the window opening and the track then divide the difference in half.
Measure from the
floor to the top of the gold pulley bracket, not the bracket base, mark this position and install.
Centre Bracket: The centre brackets are mounted horizontally.
Determine the spacing for the amount of centre brackets supplied.
Measure from the floor to the flat tab/tongue at the very front of the clip that fits into the top of the track, using the same measurement as with the pulley bracket. Install all centre brackets. The track can now be clipped into position to allow accurate
placement of the final end pulley bracket.
Attaching the track to the brackets:
Clip the track into the right hand pulley bracket by angling the pulley at 45 degrees and put into the middle slot, the other slots are for
adjustment up or down.
Clip the track onto the centre brackets by pushing the track onto the brackets. Do not pull up or down on the brackets.
The left hand pulley bracket can now be measured and installed. To help with this, unclip the track
from the nearest centre bracket, DO NOT UNCLIP THE TRACK FROM ALL BRACKETS. Install the final bracket. Re-clip the track onto the end bracket first the centre bracket.
Unclipping the Track
To remove the track, push on
the centre spring of clip brackets. Do not pull the track up, down or away from the wall without holding down the centre spring on the bracket.